Sun Fire V890 server on Rental, Upgrade or Repair

Sun Fire V890 Specifications:

Processor Options

Up to eight 1.2GHz or 1.35GHz UltraSPARC IV

1.5GHz, or 1.8GHz UltraSPARC IV+

Architecture Superscalar SPARC® V9

Processor modules One or Quad processor/ memory module

Cache (L1) 64-KB data and 32-KB instruction per pipeline

Secondary (L2) 8MB external per processor

Processing power is provided by up to four CPU/Memory boards. Each board incorporates,Two dual-threaded UltraSPARC processors  Local static random access memory (SRAM) external cache memory Slots for 16 memory modules (eight per processor) A fully configured system includes a total of eight UltraSPARC processors residing on four CPU/Memory boards.

Main Memory

Total of 16 DIMM memory slots available per CPU/Memory board 512MB, 1GB, or 2GB

(32GB maximum per CPU/Memory board, 128GB maximum when configured with 8 processors)

Note: Install DIMMs in groups of four, 232-Pin 7-nS memory modules.

System main memory is provided by up to 64 dual inline memory modules (DIMMs), which operate at a 75-MHz clock frequency. A variety of DIMM capacities are supported.

Standard/Integrated Interfaces

One Gigabit Ethernet (1000BASE-T) dual SC fiber optic port

One Ethernet/fast Ethernet (10BASE-T/100BASE-T)

Twisted-pair standard connector (RJ-45)

The system provides two on-board Ethernet interfaces—one Gigabit Ethernet and one Fast Ethernet interface. The Gigabit Ethernet interface operates at 1000 megabits per second (Mbps). The Fast Ethernet interface can operate at 10 or 100 Mbps and negotiates automatically with the remote end of the link (the link partner) to select a common mode of operation.

PCI

PCI slots are hot-pluggable

Seven slots, 64 bit, operating at 33MHz (5V)

Two slots (slots 7 and 8), 64 bit, operating at 33 or 66MHz (3.3V)

Seven slot operating at 33-MHz, 64 or 32 bits wide, 5 volts

System I/O is handled by four separate Peripheral Component Interconnect (PCI) buses. These industry-standard buses support all of the system’s on-board I/O controllers in addition to nine slots for PCI interface cards. Seven of the PCI slots operate at a 33-MHz clock rate, and two slots operate at either 33 or 66 MHz’s All slots comply with PCI Local Bus Specification Revision 2.1 and support PCI hot-plug operations. You can hot-plug any standard PCI card, provided a suitable software driver exists for the Solaris Operating System (Solaris OS) and the driver supports PCI hot-plug operations.

Remote System Controller

The Sun Fire V890 server provides two serial communication ports, which are accessed through a single, shared DB-25 connector located on the system rear panel. The primary port is capable of both synchronous and asynchronous communication, while the secondary port is asynchronous only. An optional serial port splitter cable is required to access the secondary serial port.

Mass Storage and Media

16X ATAPI DVD-ROM Drive

 Internal disk

Up to twelve 3.5″ × 1″ 10000 RPM FC-AL disks, 73GB and 146GB capacity.

Maximum total capacity of 1.75TB.

Power Supplies

2 minimum, 3 for N+1 redundancy, individual power cords 1629W maximum per power supply.

The basic system includes three 1629-watt output, 200–240-VAC input, and power supplies with internal fans. Two power supplies provide sufficient power for a maximally configured system. The third power supply provides N+1 redundancy, allowing the system to continue operating should any one of the power supplies fail. Power supplies in a redundant configuration are hot-swappable, so that you can remove and replace a faulty power supply without shutting down the operating system or turning off the system power. .

Sun Fire V890 Features:

• 64-bit Chip Multithreading (CMT) UltraSPARC® IV technology, with over 2x the throughput of previous generations
• Scales up to 8 x 1.35-GHz UltraSPARC IV CPUs with 16 MB L2 cache per processor
• Up to 16 simultaneous compute threads with up to 64 GB memory
• SolarisTM 8, Solaris 9, and Solaris 10 Operating System
• Robust capabilities in the Solaris 10 OS such as Predictive Self-Healing to increase reliability, Solaris Containers for increased utilization, and dTrace to optimize application performance
• Industry leading price/performance and benchmarks
• 9.6-GB/second Sun TM Fireplane interconnect
• N+1 hot-swap power supplies/ hot-pluggable disks
• Sun Systems Controller for remote system administration
• Automatic System Recovery to maximize uptime
• Integrated Fiber Channel disk subsystem, multipathing-ready,  supporting up to 12 FC-AL disks
• 9 PCI slots help ensure a highly scalable, well-balanced system